1. Using a level and the center mark, tape installation template to the wall using masking tape.

2. Drill holes in wall with a 1/16" bit for drywall and a 5/64" drill bit for wood paneling. Drill the holes as indicated on your template.

3. Carefully remove template from wall and insert the corresponding letters into the holes you have drilled. Push all the way in using the palm of your hand. (We recommend saving the template for re-use in the future.)

Note: Any questions please call 800-846-5646.

Materials Needed:
Level
Tape Measure
Masking Tape
Drill
1/16" Drill bit

1. Center & level template on wall. (As seen in "Pin Mount")

2. When in desired position, pre-drill holes as marked on template using a _" drill bit.

3. Remove template from wall & pound plastic anchors flush to wall.

4. Then drill center of anchor out with 3/16" drill bit.

5. Insert threaded studs in back of sign.

6. Align studs with anchors & press firmly into wall.

Note: Any questions please call 800-846-5646.

Materials Needed:
Level
Tape Measure
Hammer
Masking Tape
Drill
_" drill bit
3/16" drill bit